Table of Contents
Advertisement
Alert 1-9 - The scanner sounds a specialized beep to notify you of a Close Call hit. When you select an alert type, the
scanner automatically enters the setting of the Alert volume level. Each alert has a unique one or sound pattern.
Set CC Pause — Lets you select how long the scanner waits after a hit before it returns to the previous operation. Your
options are:
3/5/10/15/30/45/60 sec.
Infinite — The scanner stops and requires you to manually select another operation to enable its return.
Set CC Bands — Lets you select the Close Call band settings. You can turn the following bands on or off.
VHF Low 1 — (25.0000-53.9800 MHz)
VHF Low 2 — (54.0000-107.9000 MHz)
Air Band — (108.0000 - 136.9750 MHz)
VHF High 1 — (137.0000-224.9800 MHz)
VHF High 2 — (225.0000-319.9750 MHz)
UHF — (320.0000 - 512.0000 MHz)
800MHz+ — (764.0000 - 775.9875 MHz, 794.0000 - 823.9875 MHz, 849.0125 - 868.9875 MHz,
894.0125 - 956.0000 MHz,1240.000 - 1300.0000 MHz)
Use the Scroll Control
undesired bands speeds up Close Call operation (works for all frequencies listed above).
Close Call Hits
When the scanner detects a Close Call hit, it alerts you according to the Override and Alert settings in the previous section. While
listening to a Close Call hit, you can press [HOLD/RESUME] to hold on the hit frequency, press
memory, press [L/O] to lock out the frequency from Close Call and Search operation, or wait for the transmission to end. If you are in
Close Call Only or Close Call Override mode, and you do not press any key, the scanner returns to its previous operation after the
transmission ends and the set delay time expires.
If you are holding on the frequency, press [HOLD/RESUME] again to resume the previous operation.
Close Call Hits are just the last 10 hits received in Close Call mode. The hits go away when you cycle power (if you want to store
◙
it "permanently" press
when the scanner is on the frequency; the scanner then stores the frequency into the "Close Call" system
which does show up in the systems list).
Close Call Hits with Scan
When you turn on this option, the scanner automatically stores and scans the last 10 Close Call hits received. You can assign a
Quick Key to this special scan and you can also set how long the scanner will wait after the signal stops before resuming scan. This
lets you continue to hear transmissions detected with the Close Call feature, even after you are no longer close enough to receive it
as a Close Call hit. Follow these steps to set up the option.
[MENU]
Close Call
◙
Hits with Scan
Set Quick Key or Set Lockout or Set Hold Time
Set the available option as you would for other menu items.
This special channel group is automatically cleared whenever you cycle the scanner's power. To permanently save one of the
channels, press [E
] when the scanner is stopped on one of the frequencies. To keep the scanner from repeatedly stopping on an
YES
annoyance hit, press [L/O] when the scanner stops on the frequency.
Search and Close Call Options
The settings in this section affect custom searches, service searches, and Close Call operation. The following table shows what
options are available for various search modes.
◙
to select a band, press
, then use the Scroll Control to select On or Off and press
◙
◙
53
◙
. Turning off
◙
to quickly save the frequency into
Hide quick links:
Advertisement
Table of Contents
