Uniden Trunk Tracker IV BCD996T User Manual page 40

•
If the scanner cannot detect a control channel on an EDACS or Motorola system, it immediately moves to the next site or
system. The scanner always scans LTR or SCAT systems for at least 1 second to check for current activity.
•
If you select 0 and the control channel is received, the scanner stays on the system for a minimal time (only long enough to
check current system activity).
•
The default setting is 2 seconds for each system.
•
The scanner moves to the next system after the hold time expires, any current transmission ends, and the channel delay
time expires.
Editing the Band Plan
In order for the scanner to scan Motorola VHF and UHF sites, you must enter parameters that allow the scanner to determine the
frequencies in use by the system. This information is normally available at the same source where the other system information is
found.
[MENU]
Program System
Select a trunked system
◙
Edit Site
◙
Select a site
Edit Band Plan
You can enter up to 3 band plans. Select the plan to enter or edit, then follow the prompts to enter the Base Frequency, Channel
Step, and Channel Offset for the site.
Setting Control-Channel Only Mode
[MENU]
Program System
Select a trunked system
Edit Site (current)
Select a non-P25 site
◙
Set C-Ch Only
This setting determines the frequencies you need to enter for Motorola systems. Select your setting, then press
On - You only need to enter control channel frequencies.
Off - You must enter all voice and control channel frequencies.
Note: The scanner defaults to On.
Setting Site Location Information
[MENU]
Program System
Select a trunked system
Edit Site (current)
◙
Select a site
Set LocationInfo
This setting control whether the system is automatically enabled and disabled when you connect a GPS to the scanner.
Set Latitude – Enter the system's latitude using the format you selected in the system settings.
Set Longitude – Enter the system's longitude using the format you selected in the system settings.
Set Range – Set the system's range using the units you selected in the system settings.
Set GPS Enable – Depending on the data received from the GPS, the L/O status of the site is automatically
◙
◙
◙
◙
◙
◙
◙
◙
◙
◙
◙
M (VHF and UHF only)
M (except for P25)
40
◙
.
MESL
controlled.