Yamaha R-N602 Firmware Update Procedure

Hide thumbs Also See for R-N602:

Download this manual

IMPORTANT NOTICE

Follow the instructions carefully and do not attempt any other procedures not specified in the instructions

provided by Yamaha. Improperly updated products may cause improper operation, and any parts or service

required to restore proper operation will not be covered under the Yamaha Limited Warranty.

[ Firmware Update by USB ]

Requirements:

・ USB thumb drive, with enough free space to store the firmware.

(File system with FAT16 or FAT32 format)

・ Firmware file provided by Yamaha.

(Unzip program file and BIN file will appear. Copy the BIN file to the root directory of an USB drive.)

STEP 1

Turn off the unit.

STEP 2

Insert the USB thumb drive on the front panel.

STEP 3

While holding down RETURN on the front panel, press power.

STEP 4

"ADVANCED SETUP" will be shown for seconds.

STEP 5

Rotate SELECT/ENTER to select firmware update mode as shown below.

STEP 6

Press DISPLAY to start the update.

note:

DO NOT

In case the power is accidentally cut off, the R-N602 will restore original firmware. Perform the

update procedure from STEP 1 again.

Update is completed when "UPDATE SUCCESS", "PLEASE...", "POWER OFF!" is

displayed alternately. Then, power off the unit.

Firmware Update Procedure for R-N602

DIMMER

UPDATE・・・・・USB

interrupt the power or press any buttons during the update.

Page 1 DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the R-N602 will restore original firmware. Perform the update procedure from STEP 1 again. Update is completed when “UPDATE SUCCESS”, “PLEASE…”, “POWER OFF!” is...
Page 2: Troubleshooting
VERSION … X.XX (X.XX shows actual firmware version.) Congratulations! You have completed the firmware update. Your R-N602 is ready for normal use. [ 3. Troubleshooting ] In case error message appeared during the update and unable to power on, perform following update procedure.