Table of Contents
Advertisement
Preparation
Use the remote control unit by pointing it towards the remote control sensor on the
TV. Objects between the remote control unit and the remote control sensor may
prevent proper operation.
Do not expose the remote control unit to shock, in addition, do not expose the remote
control unit to liquids, and do not place in an area with high humidity.
,, Do not install or place the remote control unit under direct sunlight. The heat may cause
deformation of the remote control unit.
The remote control unit may not work properly if the remote control sensor on the TV is
under direct sunlight or strong lighting. In such cases, change the angle of the lighting or
the TV, or operate the remote control unit closer to the remote control sensor.
,,I/
2
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna
terminal
at the rear of the TV set.
"1. A 75-ohm system [s generally a round cable with F-type "
connector that can easily be attached to a terminal
without tools (Commercially available).
F-type connector
__
75-ohm coaxial cable (round)
2. A 300-ohm system is a flat "twinqead" cable that can be
attached to a 75-ohm terminal through a 300/75-ohm
adapter (Commercially available).
.......
S00-ohm twin-bad cable (flat)
k,
f
Connecting
Antenna
Cable
F-type
connector
should
be finger-
tightened
only.
When connecting the RF cable to the TV set, do not
tighten F-type connector with tools.
If tools are used, it may cause damage to your TV
set. (The breaking of internal circuit, etc.)
Fqype connector
75-ohm coaxial cable
Home
Antenna
terminal
(75 ohm)
0-12
Advertisement
Table of Contents
