Attaching The Stand - Sharp Aquos LC 46SE94U Operation Manual

QUICK REFERENCE
■
LC-46SE94U/LC-52SE94U
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
1 Confi rm that there are 4 screws and a screwdriver
supplied with the speaker unit.
Insert the projections on the speaker unit into the
2
corresponding slots on the TV, then fasten the screws.
3
Soft cushion
Insert and tighten the 4 screws with the screwdriver
(supplied with the product) in the order of 1, 2,
3 and 4.

Attaching the Stand

• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Confi rm that there are 12 screws (all the same size)
1
supplied with the TV.
1 Set the post for the stand unit onto the box.
2
2 Attach the base to the post.
3 Insert and tighten the 8 screws into the 8 holes
on the bottom of the base.
Hex key
2
6
Screwdriver
Screws
1 4
2
3
Screws
1
3 Connect the ends of the cables to the speaker
terminals as shown below.
Connect the leads to the speaker terminals of the
same color.
Black
Black
• To detach the speaker unit, perform the steps in reverse
order.
1 Insert the stand into the openings on the
3
bottom of the TV.
2 Insert and tighten the 4 screws into the 4 holes
on the rear of the TV.
2
Soft cushion
• To detach the stand, perform the steps in reverse order.
Red
Red
Hex key
Screws
1