Antenna Setup - Digital; Antenna Setup-Digital - Sharp Aquos LC 26D6U Operation Manual

Basic adjustment settings
Channel memory setting
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "CH Setup", and then
press ENTER.
• If you already set the Secret No., input the 4-
digit secret number here. See page 40 for
setting a secret number.
4
Press a/b to select "CH Memory", and then
press ENTER.
5
Press a/b to select ANALOG, DIGITAL (Air),
DIGITAL (Cable) and CableCARD, and then
press ENTER.
6
Perform the following steps after confirming
the type of antenna connection made with
your TV, and the channel type selected in
Step 5.
When viewing ANALOG broadcasts:
1 Press a/b, and then press c/d to select
the channel to skip or not.
2 Press a/b to select "Skip", and then press
c/d to select "On" or "Off".
When viewing DIGITAL broadcasts:
1 Press a/b to select the channel to skip or
not, and then press c/d to select "On" or
"Off".
• On: Skips channels. (Channel selection disabled using
r r s s
r /s r s .) s
CHr
• Off: Does not skip channels. (Channel selection enabled
r /s r r s s .) s
r s
using CHr
NOTE
• Make sure what kind of connection is made with your TV.
22
Antenna Setup – DIGITAL
In order to receive digital air broadcasts, you need a
digital broadcast antenna. You can confirm the antenna
configuration through the "Antenna Setup - DIGITAL"
screen.
If necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal Strength
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Antenna Setup -
DIGITAL", and then press ENTER.
• If you already set the Secret No., input the 4-
digit secret number here. See page 40 for
setting a secret number.
4
Press a/b to select "Signal Strength".
• The signal strength of the DIGITAL (Air) antenna
is displayed. The signal information is based
on the current channel.
Signal Strength
Channel Strength
Cable Reception
Channel Strength
• The channel signal strength can also be checked
separately.
1
Repeat steps 1 to 3 in Signal Strength in

Antenna Setup - DIGITAL.

2
Press a/b to select "Channel Strength", and
then press ENTER.
3
Input the 2-digit channel number to check
the signal strength of the selected channel.
• Make sure the appropriate signal strength of
each channel received is obtained.
Signal Strength
Channel Strength
Cable Reception
NOTE
• This function is available for DIGITAL (Air) only.
Signal Strength
Current 0 Max 0
1 2
CH
Signal Strength
Current 0 Max 0