Changing Channels-Air/Cable - Sharp Aquos LC 26D6U Operation Manual

Watching TV

Changing channels-Air/Cable

You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below .
Method 1
Using CHr/s on the remote control unit or on the TV.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
• FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons 0–9,
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5 s ENT
Air
5
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0–9 only, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1 s 1 s 5
Cable
1
To select a 4-digit channel number
(e. g., Channel 22.1):
s• (DOT) s1s
Press 2 s 2
Air Air
2 22
NOTE
• When you enter 0–9 only, channel selection will be made
if there is no operation for a few seconds.
• If you push "0" by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter 0–9 and • (DOT), channel selection will
be made if there is no operation for a few seconds.
16
(DOT) to select
•
Air ANALOG
5
Cable Cable ANALOG
115
11
ENT
Air Air Air
22. 22.1
DIGITAL
22.1