Settings; Information List - Siemens SIPROTEC 4 7VE61 Manual

NOTE
i
i
Setting address 610 FltDisp.LED/LCD to (Target on TRIP) is only reasonable if address 615 T MIN
LED HOLD is set to 0.
Die Einstellung der Adresse 610 FltDisp.LED/LCD auf (Target on TRIP) ist nur sinnvoll bei Einstel-
lung von Adresse 615 T MIN LED HOLD auf 0.
[logik-ruecksetz-gesp-led-081024, 1, en_GB]
Figure 2-2
Default display of a 4-line display
After startup of the device featuring a 4-line display, measured values are displayed by default. The arrow keys
on the device front allow different displays of the measured values to be selected for the so-called default
display. The start image of the default display, which is displayed by default after startup of the device, can be
selected via parameter 640 Start image DD. The available representation types for the measured value are
listed in the Appendix.
2.1.1.2

Settings

Addr. Parameter
610 FltDisp.LED/LCD
615 T MIN LED HOLD
640 Start image DD
2.1.1.3

Information List

No. Information
- Reset LED
- Test mode
- DataStop
- UnlockDT
- >Light on
SIPROTEC 4, 7VE61 and 7VE63, Manual
C53000-G1176-C163-3, Edition 10.2017
Creation of the resetting command for stored LEDs / relays
Setting Options
Target on PU
Target on TRIP
0 .. 60 min
image 1
image 2
image 3
image 4
Type of
Informa-
tion
IntSP
IntSP
IntSP
IntSP
SP
Default Setting Comments
Target on PU Fault Display on LED / LCD
5 min Minimum hold time of latched
LEDs
image 1 Start image Default Display
Comments
Reset LED
Test mode
Stop data transmission
Unlock data transmission via BI
>Back Light on
Functions
2.1 General
27