Sharp FOD-C525 Networking Manual page 107

2
START/
Press and then
ENTER
FAX TRANSFER SETTING.
3
START/
Press . Make sure that SET is
ENTER
selected.
4
START/
Press .
ENTER
5
Enter a 2-digit number from 01 to 41. This number is used to identify the
set that you are storing.
6
Enter a name for the set by pressing the letter entry keys (see Step 6 on
page 26). (Maximum of 20 characters.)
If you don't want to enter a name, go directly to Step 7.
7
START/
Press .
ENTER
•
If "TRANSFER ALL" has already been
selected for a set, or if you are storing
the set from a personal book, you must
enter one or more sender's numbers
(the display at right does not appear).
Go to step 10.
8
Press or
faxes from specific sender's numbers.
Select TRANSFER ALL if you wish to forward all received faxes.
9
START/
Press .
ENTER
•
If you selected TRANSFER ALL in Step 8, go to step 12.
to select
to select INPUT TSI# if you wish to only forward
Inbound Routing
ENTRY MODE
07:SYSTEM # MODE
08:STORE JUNK FAX #
09:DEPT. PASSCODE
10:BOOK ENTRY MODE
11:FAX TRANSFER SETTING
FAX TRANSFER SETTING
3:ENTRY MODE
1=SET
ENTER #(01-10, ,
2=CLEAR
3=ON/OFF
FAX TRANSFER SET
SETTING #=
FAX TRANSFER SET # 01
3:ENTRY MODE
1=INPUT TSI#
ENTER #(01-10, ,
2=TRANSFER ALL
The set number
appears here
)
)
105