Sharp FO-4470 Facsimile Operation Manual page 115

Setting 23: QUICK ON-LINE
When you transmit a multi-page document, this setting determines whether
the fax machine will dial the receiving party and begin transmitting while
scanning is still in progress, or wait until all pages have been scanned before
dialing. Press to have the fax machine dial and begin transmission while
1
scanning is still in progress, or
have been scanned.
♦
Initial setting: 1
Setting 24: MULTI TTI
If you are using Department Control, you can press
department name (the name associated with the department code entered by
an operator to access the fax) appear at the top of each transmitted
document. This will appear in place of the name entered in Entering Your
Name and Fax Number in Chapter 1. Press
sender's name entered in Chapter 1 will appear).
♦
Initial setting: 2
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, or copying. Press
no beep.
♦
Initial setting: 1
Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing codes for
telephone billing on a PBX. (Your dealer must first activate Department
Control or direct billing code entry.) Press
to turn it off.
2
♦
Initial setting: 2
If you pressed , the BILLING CODE DIAL selection will subsequently
1
appear. Press if your PBX must receive the billing code before dialing a
1
telephone number, or
telephone number. (Refer to your PBX manual or consult your PBX
adminstrator for this information.)
to have the fax machine wait until all pages
2
for 3 seconds,
1
if it must receive the billing code after dialling a
2
Optional Settings
to have the
1
to turn Multi TTI off (the
2
for 1 second, or
2
to turn telephone billing on, or
1
for
3
113