Connecting To A Network - Sharp AR-208D Operation Manual

CONNECTING TO A NETWORK

After the network expansion kit has been installed in the
machine, connect a LAN cable to the LAN connector of
the network expansion kit.
Use a network cable that is shielded.
CHECKING THE IP ADDRESS
To check the IP address of the machine, hold down the status button on the network expansion kit at
least 2 seconds to print out a Printer Setting List.
Status button
HOW TO RESET THE NETWORK EXPANSION KIT
To reset the network expansion kit, turn on the power while holding down the status button on the
network expansion kit. Continue to hold down the status button until a beep sounds.
Network scanner destination information and scanning settings will remain after the network
Caution
expansion kit is reset, however, the network settings and printer settings will revert to the factory
default settings.
- 8 -