Copier Trouble - Sharp AR-201 Operation Manual

COPIER TROUBLE?

Problem
Copies are smudged
or dirty.
Paper size for a paper
tray cannot be set.
Power is on but copying
is not possible.
48
Original table or platen cover dirty?
Original smudged or blotchy?
Is the indicator on?
Is the indicator on?
Is the COPY indicator off?
Is copying, printing or facsimile
printing being performed?
Is the POWER SAVE ( ) indicator
blinking?
Is only the POWER SAVE (
indicator on?
Is the COPY indicator off?
Is steadily lit in the copy quantity
display?
Is the indicator on?
Solution
Clean regularly. See page 45.
Use a clean original.
Developer is required. Contact your SHARP
service centre as soon as possible. See page 35.
Maintenance is required. Contact your SHARP
service centre as soon as possible. See page 35.
Use the COPY/FAX key to select the COPY
mode. See Note below.
Set the paper size after copying, printing or
facsimile printing is complete.
Wait until warm-up is complete.
Warm-up time is approximately 35 seconds.
) The copier is in the auto power shut-off mode.
Press the START (
SAVE MODES.
Use the COPY/FAX key to select the COPY
mode. See Note below.
The copier is in the auditing mode.
Enter your account number using the numeric
keys. See page 13.
Copy paper is needed. See page 10, LOADING
COPY PAPER.
COPY/FAX key
The COPY/FAX key is used to switch
between the FAX and COPY modes.
For details, see the MULTI ACCESS
manual.
) key. See page 43, POWER