Maintenance EN18 Attached with a warranty card Attached with a warranty card Troubleshooting EN21 Thank you for purchasing Panasonic product. Product disposal EN25 All illustrations used are for explanation purposes, actual item may vary slightly from those shown. Specifi cations...
Part Names Part Names With the touch With the touch Let ' s check the accessories of a of a button button Parts enclosed in are included accessories. Start cleaning from the charging base or anywhere else! Remote controller Thorugh button (P. EN13) The house dust detector lamp house dust detector lamp fi...
Main unit Rotating brush Side brush (R) Recharging Wheel terminals Brush cover Side brush (L) Wheel Battery cover Roller Rechargeable battery is inside Infrared receiver Sensors Sensors Receives the infrared signals from the charging base and The infrared sensors and fall prevention sensors ...
Safety Precautions Safety Precautions Please make sure to follow these instructions In order to prevent accidents or injuries to the user, other people, and damage to property, please follow the instructions below. The following charts indicate the degree of damage caused by wrong operation. Indicates a potentially hazardous Indicates a potentially hazardous situation which, if not avoided,...
Page 5
To avoid fi re, burns, electric shock and etc. Do not smoke or carry combustible matter Do not smoke or carry combustible matter (So as to avoid an explosion or fi re) Cigarettes, toner from a copier, heating fuels, thinners, etc. Do not touch the rotating brush, wheels or side brushes Do not touch the rotating brush, wheels or side brushes (Danger of injury and burns)
Page 6
Safety Precautions Safety Precautions Please make sure to (continued) (continued) follow these instructions To avoid fi re, burns, electric shock and etc. Children should be supervised to ensure that they do not play with the Children should be supervised to ensure that they do not play with the appliance appliance (It may cause fi...
Page 7
To avoid ignition, injury and etc. Do not approach the fi re source or the heat source, and avoid Do not approach the fi re source or the heat source, and avoid direct sunlight direct sunlight (This can cause fi re or deformation) Do not spy on the vacuum cleaner during operation Do not spy on the vacuum cleaner during operation (This can cause falls and injury)
Page 8
Safety Precautions Safety Precautions Please make sure to (continued) (continued) follow these instructions To avoid fi re, burns, electric shock and etc. Keep batteries out of the reach of infants and children Keep batteries out of the reach of infants and children (This can cause accidents and injury) ...
Notes on Use Notes on Use The vacuum cleaner is a household vacuum cleaner and should not be used for commercial or industrial purposes and for other purposes other than dust absorption. Do not allow the unit to suck the following objects (This can cause malfunctions and odours) ...
Before use Before use Getting the room ready Do one of the following to ensure smooth operation. Do one of the following to ensure smooth operation. Tidy up before starting Please move items to other rooms Place a weight that can be used as a guard bar before ...
Page 11
Set up the charging base Set up the charging base Put the charging base Put the charging base up against the wall up against the wall (This is to make sure the charging base doesn ' t move by being pushed by the main unit) The location should be The location should be...
Page 12
Charging Charging The battery is not fully charged at the time of purchase, so please be sure to charge before use (full charge takes about 2.5 to 5 hours) To help make the battery last longer To help make the battery last longer If the unit is not used for one month or more, charge the unit fully, turn the main power switch off for ...
Cleaning Cleaning Open the main power switch, and Open the main power switch, and Using Using enter the dormant state ... enter the dormant state ... Always on Normal Press and hold the main unit or remote Flashing Limited power controller to enter the standby mode, Abnormal...
Page 14
Cleaning Cleaning (continued) (continued) Borderline mode Borderline mode Spot mode Spot mode Arch mode Arch mode The main unit automatically goes With the start position as the center, The vacuum cleaner stays in the straight to the wall, and then clean the vacuum cleaner fi...
Other operations Other operations Using the remote controller Using the remote controller When using the remote controller When using the remote controller • The remote controller can be used within a range of about 5 m • Point the infrared transmitter of the remote controller at the infrared receiver of the main unit •...
Page 16
Disposing of the dust (Maintenance) Disposing of the dust (Maintenance) Empty the dust box (Maintenance) Empty the dust box (Maintenance) Please turn off the main Please turn off the main power switch before power switch before cleaning the rubbish cleaning the rubbish Empty the dust box and perform maintenance as necessary.
Page 17
Open the cover Open the cover While opening Dispose of the dust Remove the dust Remove the dust box and empty it box and empty it In this process, the suction inlet is facing upwards to Face the suction ...
Maintenance Maintenance When garbage is wrapped/When deemed necessary When garbage is wrapped/When deemed necessary Before performing any maintenance, turn off the main power switch and unplug the power plug from the AC adapter Underneath the main unit · Rotating brush Underneath the main unit ·...
Page 19
Main unit · charging base Main unit · charging base Wipe with a soft, wet cloth Wipe with a soft, wet cloth which has been wrung out which has been wrung out Non- washable Sensors · Infrared receiver/ Sensors · Infrared receiver/ Infrared transmitters Infrared transmitters Wipe the...
Maintenance Maintenance (continued) (continued) When garbage is wrapped/When deemed necessary When garbage is wrapped/When deemed necessary Before performing any maintenance, turn off the main power switch and unplug the power plug from the AC adapter Side brush Side brush Remove rubbish from Remove rubbish from areas areas...
Troubleshooting Troubleshooting Check the following before requesting repairs. When this happens When this happens Inspection and handling Inspection and handling The power doesn ' t come The battery is depleted. on even when you turn the → Recharge the battery. (P. EN12) main power switch on.
Page 22
Troubleshooting Troubleshooting (continued) (continued) Check the following before requesting repairs. When this happens When this happens Inspection and handling Inspection and handling The unit seems to be Are the infrared sensors dirty? bumping into obstacles → Perform maintenance (P. EN19) more than previously Are the fall prevention sensors dirty? ...
Page 23
When this happens When this happens Inspection and handling Inspection and handling Is the plug of the AC adapter plugged into the socket outlet? Is the main power switch on? Is the main unit set properly into the charging base? ...
Page 24
Troubleshooting Troubleshooting (continued) (continued) Check the following before requesting repairs. When this happens When this happens Inspection and handling Inspection and handling Is the plug of the AC adapter plugged into the socket outlet? Is there an obstacle within about 150 cm in front of the charging base or ...
Product disposal Product disposal The Robotic Vacuum Cleaner is equipped with rechargeable lithium-ion battery and dry battery. To protect the environment, remove the battery (lithium-ion battery and battery) and carry them to the appropriate collection site when discarding the product. Do not disassemble the battery or stack it with the general household waste so as to prevent contamination of the environment.
Specifi cations Specifi cations Specifi cations Specifi cations Model No. MC-RS765W487 Dust capacity 0.25 L 71 dB (A) Noise ( Main unit ) 332 mm × 328 mm × 86 mm Dimensions (Depth × Width × Height) 2.6 k ( Main unit only )