Set Pass Code - Honeywell Midas User Manual

11. Use the 's' up or 't' down buttons to change
the address setting (between 0 and 255).
12. Press '3' accept and repeat for the second, third
and fourth subnet values. The number of dots in
the upper left indicates which part of the subnet
address is being viewed.
13. Press '3' to update the changes (UPdt displayed).
The unit will request a reboot to implement the
IP configuration.
Note
If the IP address is changed the new settings
will not be implemented until the Midas®
unit is rebooted.
Midas
7.2.8 Set pass code ' PWd'
1. Select the set pass code ' PWd' submenu and
press '3' to accept.
2. P r e s s ' s '
s e t t h e f i r s t
(Note: Holding down the button will increase the
increment speed).
3. Press '3' to enter the first value and move to
setting the second value.
4. Press 's' up or 't' down to set the second value.
5. Press '3' to enter and repeat for the third and
forth values in the passcode.
6. To confirm the pass code re enter it again using
the same procedure.
7. The new pass code will be saved after the last
entry if the two entered passcodes are the same.
Note
Pass codes can be set between 0001 and
9999. Setting the pass code to 0000 will
switch off the pass code. If a pass code is
forgotten contact your local Honeywell
Analytics service department. In the event
that a pass code is forgotten by the user,
Honeywell Analytics is not responsible
for any costs associated with the recovery
of the passcode nor for any inconvenience
incurred while the user is unable to access
protected settings. It is strongly advised
that the user record all pass codes with the
instrument serial number in a secure and
separate location to the Midas® unit. Delays
in recovering the lost passcodes may be
experienced and are not the responsibility
of Honeywell Analytics.
7-12
Gas Detector
®
u p o r ' t ' d o w n
p a s s c o d e
t o
v a l u e .