Table of Contents
Advertisement
h. Select the Configure LPVID option.
3. Configure unique VLANs as necessary for each Ethernet vNIC.
a. This feature works by applying VLAN tags to the traffic egressing the adapter and entering the
network. Thus, for correct operation, the VLAN tags on the physical network port to the adapter must
match. Note that a VLAN ID cannot be assigned for the FCoE vNIC.
b. Make sure that the VLANs are configured and allowed on the internal and external switch ports as
needed.
c. Configure the network port attached to the server. Use the following configuration as a reference.
interface Ethernet191/1/7
switchport mode trunk
switchport trunk native vlan 182
switchport trunk allowed vlan 182,200
spanning-tree port type edge trunk
channel-group 207
interface port-channel207
switchport mode trunk
switchport trunk native vlan 182
switchport trunk allowed vlan 182,200
spanning-tree port type edge trunk
© 2014 Cisco | IBM. All rights reserved.
Page 34
Advertisement
Table of Contents
