AEG FSE21200P User Manual page 12

12 www.aeg.com
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate
spotting
Empty
1. To open the dispenser, turn the cap to
the "open" (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser,
being careful not to overfill.
3. Replace the cap by inserting it aligned
with "open" arrow and turning it to the
closed (right) arrow.
C (Rinse-aid
indicator)
Adjusting Rinse Aid
Dispenser
The rinse aid dispenser has six or four
settings. always start with the dispenser
set on "4". if spots and poor drying
are problems, increase the amount of
rinse aid dispensed by removing the
dispenser lid and rotating the dial to
"5". if the dishes still are not drying
properly or are spotted, adjust the dial
to the next higher number until your
dishes are spot-free. The recommended
setting is "4". (Factory value is
" 4 " . )
NOTE:
Clean up any rinse aid split during
filling with an absorbent cloth to
avoid excessive foaming during
the next wash. Don't forget to
replace the cap before you close
dishwasher door.
NOTE:
increase the dose if there are
drops of water or lime spots on the
dishes after washing.
Reduce it if there are sticky whitish
stains on your dishes or a bluish
film on glassware or knife blades.
adjust lever
(Rinse)