Advertisement
5
TOP DOWN CELLULAR SHADES (CONTINUED)
INSTALLATION
Note: Remove the two cardboard end caps and other packaging from the blind/shade (if
applicable), do not cut cords, shade cloth or damage blinds.
Hold the compressed shade while removing the banding, then gently lower the compressed shade
until it reaches the bottom of the hinged glass panel.
A. Ensure the operator handle is near the bottom of the hinged glass panel prior to inserting the
blind/shade. This allows for full travel of the operator handle to raise or lower the blind/shade
completely.
B. Insert the shade into the hinged glass panel frame by
sliding the operator end of the head rail over the mounting
stud while guiding the operator drive into the drive gear. It
may be necessary to move the shade operator handle up
slightly to help align the gear.
C. Secure the shade head rail by pressing the opposite end of
the rail over the second mounting stud.
D. For shades 47" or wider: Attach the shade support clip
to the top of the hinged glass panel near the center of
the hinged glass panel. However, if there is a grille that
will be attached at the center point, move the support to
the left or right of center. Next, lift up on the shade head
rail, to engage the clip.
W A R N I N G
Page 6 of 6
Mounting Stud
Operator Drive
Drive
Gear
Shade Support
Clip
Grille
Bar
Advertisement
