Advertisement
2
GRILLES
REMOVAL
Follow the steps in Instruction 1 to open the hinged glass panel.
A. Starting at the bottom, grasp the grille as close to the clip at the
end of each bar as possible and pull toward the interior.
B. Repeat step A at the end of each bar.
Note: If the grille has Stand-Offs (large windows and doors with
double pane), or Bumpers (triple pane), DO NOT remove them
from the grille.
INSTALLATION
A. Starting at the top, Align each clip with the dot matrix patterns
imprinted on the frame.
B. Snap the open side of each clip onto the frame by pressing on
the clip.
3
BOTTOM UP SLIMSHADE®
BLIND AND CELLULAR SHADES
Note: Follow the steps in Instruction 1 to open the hinged glass panel.
Follow the steps in Instruction 2 to remove the grilles (if applicable).
REMOVAL
Note: Remove the two cardboard end caps and other packaging from
the blind/shade (if applicable), do not cut cords, shade cloth or
damage blinds.
A. Place the blind/shade in the full open position.
B. For shades 47" or wider only: Remove the shade support clip
located near the center of the shade mounting channel. Remove the
clip from the bottom of the mounting channel, then remove the clip
from the hinged glass panel.
C. Release the blind/shade from the mounting stud by pulling the
plastic tab.
D. Remove the blind/shade head rail from the drive gear and second
mounting stud by sliding it away from the operator side of the
hinged glass panel.
INSTALLATION
A. Make sure the shade operator handle is near the bottom
of the hinged glass panel. This allows for full travel of the
operator handle to raise or lower the blind/shade completely.
B. To install the blind/shade, slide the operator end of the top
rail over the mounting stud, while guiding the operator drive
into the drive gear. This end is labeled "A" on the top of the
head rail. It may be necessary to move the shade operator
handle up slightly to help align the gear.
Page 3 of 6
Grille
Stand-Off
Grille
Bar
Grille
Stand-Off
Grille
Bar
Shade Support Clip
Mounting Stud
Operator Drive
Drive
Gear
Grille
Bumper
Grille
Clip
Grille
Bumper
Dot
Matrix
Pattern
Grille
Clip
Plastic Tab
Advertisement
