Advertisement
Quick Links
© 2016 Pella Corporation
INSTALLATION INSTRUCTION – INSTRUCCIONES DE INSTALACIÓN
DESIGNER SERIES® HINGED GLASS PANEL,
GRILLE, BLIND AND SHADE INSTRUCTIONS
DO NOT remove or cut the white cord that limits the opening of the hinged
CAUTION:
glass panel. Doing so may cause serious damage, including glass breakage, to your
Pella product. The cord should only be detached by a qualified service technician when
performing service related procedures.
Table of Contents:
1. Operating the Hinged Glass Panel
2. Grille Removal and Installation
3. Bottom Up Slimshade Blind and Cellular Shade Removal and Installation
4. Tilt Only Slimshade Blind Removal and Installation
5. Top Down Cellular Shade Removal and Installation
Latch
release
Shade
operator
handle
Latch
release
Casement window is shown.
Page 1 of 6
Part Number: 80ML0106
Advertisement
Summary of Contents for Pella 80ML0106
- Page 1 DO NOT remove or cut the white cord that limits the opening of the hinged CAUTION: glass panel. Doing so may cause serious damage, including glass breakage, to your Pella product. The cord should only be detached by a qualified service technician when performing service related procedures. Table of Contents: 1.
- Page 2 OPERATING THE HINGED GLASS PANEL Note: For products other than venting casement windows, proceed to Step C. Screen Clip A. Casement window with flat screen: Remove the flat screen by unlatching the screen clips and pulling the screen to the interior.
- Page 3 Grille Grille Stand-Off Bumper GRILLES REMOVAL Follow the steps in Instruction 1 to open the hinged glass panel. A. Starting at the bottom, grasp the grille as close to the clip at the end of each bar as possible and pull toward the interior. Grille Grille Clip...
- Page 4 BOTTOM UP SLIMSHADE® BLIND AND CELLULAR SHADES (CONTINUED) C. Press the opposite end of the rail over the second mounting stud. Note: Bottom-up cellular shades may appear to be too short for the unit. The shade will lengthen after hanging in the down position for a few hours. If the shade does not hang straight, open and close it completely two to three times.
- Page 5 TILT ONLY SLIMSHADE BLINDS (CONTINUED) C. Install the blind by sliding the operator end of the head rail over the mounting stud while guiding the operator drive into the drive gear. D. Secure the head rail by pressing the opposite end of the rail over the second mounting stud.
- Page 6 TOP DOWN CELLULAR SHADES (CONTINUED) INSTALLATION Note: Remove the two cardboard end caps and other packaging from the blind/shade (if applicable), do not cut cords, shade cloth or damage blinds. Hold the compressed shade while removing the banding, then gently lower the compressed shade until it reaches the bottom of the hinged glass panel.