Advertisement
4
TILT ONLY SLIMSHADE BLINDS (CONTINUED)
C. Install the blind by sliding the operator end of the head rail
over the mounting stud while guiding the operator drive into
the drive gear.
D. Secure the head rail by pressing the opposite end of the rail
over the second mounting stud.
E. There will be up to six support clips depending on the
width of the blind. Space the support clips evenly between
the cord ladders along the head rail. Do not cover locations
where grilles will be installed. Press the top of the clip onto
the hinged glass panel frame.
F. Place the shade bottom rail between the glass of the hinged
glass panel and the legs of the bottom rail retainer.
5
TOP DOWN CELLULAR SHADES
Note: Follow the steps in Instruction 1 to open the hinged glass panel.
Follow the steps in Instruction 2 to remove the grilles (if applicable).
REMOVAL
A. Place the shade in the full open position.
B. For shades 47" or wider only: Remove the center shade support clip
by taking it off of the mounting channel, then remove the clip from
the hinged glass panel.
C. Release the blind/shade from the mounting stud by pulling the
plastic tab.
D. Remove the shade head rail from the drive gear and second
mounting stud by sliding it away from the operator side of the
hinged glass panel.
Note: Take care to avoid tangling the internal cords as the shade is
removed from the window.
Page 5 of 6
Shade Support Clip
Plastic Tab
Advertisement
