Getting Help - Cisco 1710 Software Configuration Manual

Getting Help

Table 1-2 Command Modes Summary (continued)
Mode Access Method
Router Enter your
configuration router command
followed by the
appropriate
keyword while
in global
configuration
mode.
Line Specify a line
configuration with the line vty
command while
in the global
configuration
mode.
1. For any of the modes, you can see a comprehensive list of the available commands by entering a question mark (?) at the
prompt.
Getting Help
Cisco 1710 Security Router Software Configuration Guide
1-6
Prompt
1710(config-r
outer)#
1710(config-l
ine)#
You can use the question mark (?) and arrow keys to help you enter commands.
Here are some ways to get help while in any command mode:
Enter a question mark to list the commands that are available in the current
•
mode. You can restrict the list to all commands starting with a specific letter
by entering that letter, followed by a question mark (no space):
Router (config-if)# s?
shutdown
snapshot
snmp
standby
Chapter 1 Introduction to Router Configuration
Exit Method
• To exit to global
configuration
mode, enter the
end command.
To exit to
•
privileged EXEC
mode, enter the
exit command, or
press Ctrl-Z.
To exit to global
•
configuration
mode, enter the
exit command.
To enter
•
privileged EXEC
mode, enter the
end command, or
press Ctrl-Z.
1
About This Mode
Use this mode to
configure an IP routing
protocol.
Use this mode to
configure parameters for
the terminal line.
78-12696-01