Cisco 1710 Software Configuration Manual page 23

Chapter 1 Introduction to Router Configuration
Table 1-2 Command Modes Summary (continued)
Mode Access Method
Global Enter the
configuration configure
command while
in privileged
EXEC mode.
Interface Enter the
configuration interface
command (with
a specific
interface) while
in the global
configuration
mode.
78-12696-01
Prompt Exit Method
• To exit to
1710(config)#
privileged EXEC
mode, enter the
exit or end
command, or
press Ctrl-Z.
• To enter interface
configuration
mode, enter the
interface
command.
To exit to global
1710(config-i •
f)#
configuration
mode, enter the
end command.
To exit to
•
privileged EXEC
mode, enter the
exit command, or
press Ctrl-Z.
To enter
•
subinterface
configuration
mode, specify a
subinterface with
the interface
command.
Cisco 1710 Security Router Software Configuration Guide
Understanding Command Modes
1
About This Mode
Use this mode to
configure parameters
that apply to your router
as a whole.
Use this mode to
configure parameters for
the various LAN
interfaces of your router,
including the
10BaseT Ethernet
•
interface.
• 10/100BaseT
FastEthernet
interface.
1-5