About Wireless I/O (Z-Wave Plus ® ) - Axis M5065 User Manual

AXIS M5065 PTZ Network Camera
About wireless I/O (Z-Wave Plus
About wireless I/O (Z-Wave Plus
This is a security enabled Z-Wave Plus
Z-Wave Plus devices. The product can be operated in any Z-Wave network with compatible Z-Wave certified devices from other
manufacturers. To increase the network reliability, all non-battery operated Z-Wave devices in the network act as repeaters regardless
of vendor. This product acts as the control device and the Z-Wave devices added to it act as slaves.
Considerations
Before using wireless I/O with Z-Wave Plus, consider the following:
• You need to be an administrator to do the Z-Wave configurations.
• When performing Z-Wave related actions on the product's web page, such as adding, removing and replacing Z-Wave
devices or resetting the Z-Wave network, we recommend that you do not reload the page or move away from it when the
action process is ongoing. If done, the action's actual and displayed statuses may differ. To recover, you may need to wait
up to several minutes and then reload the page again.
• Replication, i.e. copying network information to another control device, is executed as part of the inclusion process.
• This product ignores all commands in the Basic Command Class.
• Some advanced Z-Wave functions are not accessible from the product's web page. Contact support to get software
to access these functions.
• If the network primary controller is missing or otherwise inoperable, you need to reset to factory default settings from the
product's web page. To do this, go to Setup > System Options > Maintenance, and click Default.
Associations
• This product supports one association group with group identifier = 1 (LifeLine).
• Maximum number of devices that can be added to the association group = 1.
• Group identifier 1 is used to send the Device Reset Locally report.
Command classes
This product supports the following command classes:
• COMMAND_CLASS_ZWAVEPLUS_INFO
• COMMAND_CLASS_TRANSPORT_SERVICE
• COMMAND_CLASS_CRC_16_ENCAP
• COMMAND_CLASS_APPLICATION_STATUS
• COMMAND_CLASS_SECURITY_2
• COMMAND_CLASS_SECURITY
• COMMAND_CLASS_INCLUSION_CONTROLLER
• COMMAND_CLASS_SUPERVISION
This product supports the following security command classes:
• COMMAND_CLASS_SECURITY
• COMMAND_CLASS_ NETWORK_MANAGEMENT_INCLUSION
®
)
®
)
®
product that can use encrypted Z-Wave Plus messages to communicate with security enabled
37