How To Replace A Z-Wave Device - Axis M5065 User Manual

AXIS M5065 PTZ Network Camera
About wireless I/O (Z-Wave Plus
1. Go to Setup > Wireless I/O.
2. Click Remove. The product starts looking for Z-Wave devices in the Z-Wave network.
3. Set the Z-Wave device to be added into inclusion/exclusion mode as described in its User Manual.
4. Wait until the removal process is finalized as indicated by Status: Done on the web page.
The Z-Wave device is now removed from the Z-Wave Device List.
Note
All product-related information in the removed Z-Wave device is erased.
Note
If the Z-Wave device is not found, the adding process is terminated automatically.
How to remove a Z-Wave device through forced process
There may be a communication fail e.g. due to drained battery so you may not be able to remove the Z-Wave device by setting
it to inclusion/exclusion mode. You can perform a forced removal of a Z-Wave device that shows status Unavailable or Sleep
in the Z-Wave Device List.
1. Go to Setup > Wireless I/O.
2. Select the Z-Wave device to be removed from the Z-Wave Device List and click Modify. The device's status information
window opens.
3. Click Remove.
4. Click OK to confirm the removal.
The Z-Wave device is now removed from the Z-Wave Device List.
Note
All product-related information in the removed Z-Wave device is retained.

How to replace a Z-Wave device

There may be a communication fail e.g. due to a faulty Z-Wave device, and you want to replace the device with another one. You can
perform a forced replacement of a Z-Wave device that shows status Unavailable or Sleep in the Z-Wave Device List.
1. Go to Setup > Wireless I/O.
2. Select the Z-Wave device to be replaced from the Z-Wave Device List and, click Modify. The device's status information
window opens.
3. Click Replace. The product starts looking for Z-Wave devices in the Z-Wave network.
4. Set the Z-Wave device that is to replace the existing device into inclusion/exclusion mode as described in its User Manual.
5. Wait until the replacement process is finalized as indicated by Status: Replacing (found node) on the web page.
The new Z-wave device with some status information is now visible on the Z-Wave Device List.
Note
Node ID and event action information is handed over to the new Z-Wave device. All other information is erased.
Note
If the Z-Wave device is not found, the replacement process is terminated automatically.
®
)
39