Advertisement
• Turn the selector (A) to the Max position to select maximum power (the Max power light
comes on).
In the fan version, both Min and Med lights come on.
5. Adjusting the thermostat
When the room has reached the required temperature, turn the thermostat dial (B) slowly
anticlockwise until the lights go out and no further. The thermostat will automatically regulate the
temperature set and keep it constant. In spring or autumn or on mild days, you can save energy
by using minimum power.
6. Frost prevention mode
With the thermostat dial in the
maintains room temperature at about 5°C, preventing freezing with minimal energy consumption.
7. Models with fan
Some models have two fans for faster more even heating. To use this function, turn the power
selector (A) to the Max position
8. Models with 24 hour timer (C)
If you wish to operate the heater without the timer, position the slider on position I.
On the contrary if you wish to operate the heater at a set time, first
put the slider (D) on position
• Check the time on your clock or watch. If it is 10.00 for example,
turn the numbered programmer disk until the number 10 coincides
with the pointer marked on the programmer.
• Set the periods of time during which you want the appliance to
operate by pushing the teeth outwards. Each tooth corresponds to
a period of 15 min. At the end of this procedure, sectors
corresponding to the operating periods can be seen.
• In this way, the appliance will function automatically each day at the
times set. (Important: the appliance must always be plugged into the
socket)
• To modify programming, return the teeth to the initial position and set the new operating
periods.
• To turn the appliance off completely, turn the dial (A) to the "0" position and unplug from the
mains.
9. Maintenance
Always unplug from the mains socket before cleaning.
The convector heater requires no special maintenance. It is sufficient to remove dust with a soft
dry cloth. Clean when cold only. Never use abrasive powders or solvents.
position and one of the power levels selected, the appliance
(the corresponding light comes on).
(fig. 5) then proceed as follows:
6
Slider
I
D
Fig.5
Advertisement
