Advertisement
Dear Customer – The plug on this appliance will get 'warm' during use, this
is perfectly normal. This product is A HIGH POWER HEATING APPLIANCE
designed to our usual high standards but please make sure your wall sockets
are in good condition and the plug is inserted correctly to avoid any
accidental overheating.
We suggest that you check the plug AND THE SOCKET regularly if the heater is
in prolonged use, if you are in any doubt please consult an electrician.
1. Electrical connections
- Before plugging into the mains, make sure the voltage of your mains supply corresponds to the
value Volt indicated on the appliance and that the socket and power line are appropriate for
the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EEC AND ON ELECTROMAGNETIC
COMPATIBILITY.
2. Attaching the feet
To fit the feet, proceed as follows: insert the foot into the guide on the side and push as far as it
will go until the two teeth hook in place (fig. 1).
3. Wall mounting
IMPORTANT: before drilling the wall, make sure the area is free of
electrical wires or pipes. To fix your convector heater to the wall, use
the brackets "E" and "F" provided and appropriate screws and wall
plugs (provided). Proceed as follows:
• Fix the brackets "E", making sure the distances are as shown in fig.
2.
• Hang the heater on the two brackets fixed to the wall. Insert the
two brackets "F" in the back of the convector base as shown in fig.
3-4.
Mark the bracket fixing points on the wall.
• Remove the heater, drill the wall and insert the wall plugs.
• Fix the heater again, inserting the brackets "F" into the base of the
heater and fixing them to the holes in the wall using the screws.
Now your heater is mounted on the wall.
The appliance must not be positioned directly
underneath a fixed power point.
Position the appliance in such a way that the plug is
easily accessible even after installation.
4. Operation and use
Turning on
Plug into the mains, turn the thermostat dial (B) to maximum and turn the appliance on by means
of the power selector (A) as described below.
• Turn the selector (A) to the Min position to select minimum power (the Min power light
comes on).
• Turn the selector (A) to the Med position to select medium power (the Med power light
comes on).
5
1
F
2
Fig.3
3
Fig.4
Advertisement
