How To Use The Diver Adjuster; Remarks On Replacement Parts; Remarks On After-Sales Servicing - Seiko Prospex 7K32 Instruction

Multi-function analogue watch equipped with an atmospheric pressure sensor
Table of Contents

Advertisement

■ HOW TO USE THE DIVER ADJUSTER

The Diver Adjuster is a bracelet mechanism to adjust the bracelet length of your Watch. It is
very useful when you wear the watch over a wet suit.
Bracelet on the
Flap
6 o'clock side
Lock button
of your watch
Clasp
Bracelet on the 12 o'clock
side of your watch
① Lift up the flap approximately 90°until it stands
upright. Do not extend the Diver Adjuster at this step.
② Lightly push back the flap further approximately
20.°When doing so,take care not to push the flap
forcibly as more force is required to do sothan to lift
up the flap.
③ Pull the bracelet on the 6 o'clock side of the watch
to extend the Diver Adjuster. Before doing this, be
sure to carry out Step (2). Otherwise, the bracelet
length cannot be extended.
The Diver Adjuster can be
extended approximately 30mm.
Extend it to the full.
④ While pressing the lock button,
⑤ lift up the clasp to release the
buckle, and put on the watch on
your wrist. Close the clasp first and
then, the flap.
⑥ Hold the bracelet on both the
6 and 12 o'clock sides of the
watch with fingers to reduce the
length of the Diver Adjuster until
it fits well around your wrist.
93

■REMARKS ON AFTER-SALES SERVICING

・ If the watch requires service, take it to the retailer from whom the watch was purchased or a
SEIKO DEALER. If the trouble occurs within the guarantee period, submit the certificate of
guarantee together with the watch.
・ For repair after the guarantee period or for any other information regarding the watch, contact
the retailer from whom the watch was purchased or a SEIKO DEALER the "CUSTOMER
SERVICE DEPARTMENT" of SEIKO CORPORATION.
・ Guarantee coverage is spelled out in the certificate of guarantee. Please read it carefully and
keep the certificate for ready reference.

■REMARKS ON REPLACEMENT PARTS

・ SEIKO makes it policy to usually keep a stock of spare parts for its watches for 7 years. In principle,
your watch can be reconditioned within this period if used normally. (Replacement parts are those
which are essential to maintaining the functional integrity of the watch.)
・ The number of years that a watch is considered repairable may vary greatly depending on the
conditions under which it was used, and normal accuracy may not be achieved in some cases.
We recommend, therefore, that you consult the retailer from whom the watch was purchased
when having them repair your watch.
・ The case, dial, hands, glass and bracelet, or parts thereof may be replaced with substitutes if
the originals are not available.
94

Advertisement

Table of Contents
loading

Table of Contents