Table of Contents
Advertisement
[One-way rotating bezel]
As the evaluation of the remaining air in your cylinder is based on the information
of the elapsed time of the dive, the rotating bezel for a diver's watch is designed to
rotate only counterclockwise, so that the watch is prevented from displaying the
elapsed time shorter than it actually is.
Make sure that you check the correct remaining amount of air in your
cylinder before diving. Use the display of the elapsed time by the rotating
bezel only as a guide during diving.
16
CAUTION
HOW TO USE THE DIVER ADJUSTER
The Diver Adjuster is a bracelet mechanism to adjust the bracelet length of your
diver's watch. It is very useful when you wear the watch over a wet suit.
Lift up the flap approximately 90º until it stands upright.
1
Press the flap down further approximately 20º, and hold it there.
2
•
You may feel slight resistance, but doing this requires only a light force.
Please do not push the flap down forcibly.
Lightly pull the bracelet on the 6
3
o'clock side of the watch along the
curved line of the bracelet.
•
Again, doing this requires only a
light force. Please do not pull the
bracelet forcibly.
•
T h e s l i d e r c a n b e p u l l e d o u t
approximately 30 mm. Be careful
not to pull it out forcibly.
1
2
Bracelet on the 12 o'clock
side of your watch
Flap
3
Bracelet on the 6 o'clock
side of your watch
17
Advertisement
Table of Contents
