Table of Contents
Advertisement
How to use an easy adjust type clasp
Some bands are provided with an easy adjust type clasp for fine adjustment of the band's length.
2
If the clasp of the watch you purchased is as follows, please refer to the following instructions.
* The band can be lengthened by up to about 5 mm.
This is useful if the band feels too tight or is uncomfortable for some reason.
33
EN
● How to adjust the length of the band
1. You can lengthen the band by up to about 5 mm
(2 stages) by firmly pressing the push buttons
2
from both sides to actuate the adjuster.
* The above illustrations are provided as examples. Some details may differ depending on the model.
35
EN
2. Fasten the clasp by pressing the frame of the
buckle.
* Even while the clasp is closed, you can still retract
the length of band extended by the adjuster.
● How to wear the band (Opening and closing the clasp)
1. Lightly press the push buttons to open the
clasp.
* Note that pressing the push buttons too
firmly (deeply) actuates the adjuster, which
lengthens the band.
2. Fasten the clasp by pressing the frame of
the buckle.
How to use the diver adjuster
If your watch's metallic band has the Diver Adjuster function, the length of the band can be easily
adjusted.
It is very useful when you wear the watch over a wet suit or winter clothing.
1
Lift up the flap approximately
90°until it stands upright, and
then press the flap down
further approximately 20°and
lightly hold it.
• When doing so, take care not to push
the flap forcibly. Although you may feel
slight resistance, doing this requires
only a light force.
2
Lightly pull the band on the
6 o'clock side of the watch
along the curved line of the
band to pull out the slider.
• Doing this requires only a light force.
Take care not to pull the band forcibly.
• The slider can be pulled out
approximately 30 mm. Take care not
to pull it out more than this limit.
Push button
Buckle
Flap
20°
90°
Band on the
6 o'clock side
of the watch
2
34
EN
2
36
EN
Advertisement
Table of Contents
