Safety Labels; Checking Unit Condition - Shindaiwa T230X EMC Owner's/Operator's Manual

Safety Labels

Figure 3

Checking Unit Condition

NEVER operate the unit with the cutting
attachment shield or other protective
devices (harness, ignition switch, blade
retention clip, etc.) removed!
WARNING!
A cutting attachment shield or other
protective device is no guarantee of
protection against ricochet. YOU MUST
ALWAYS GUARD AGAINST FLYING
DEBRIS!
Use only authorized Shindaiwa parts and
accessories with your Shindaiwa trimmer
or brushcutter. Do not make modifi cations
to this unit without the written approval of
YAMABIKO CORPORATION.
ALWAYS make sure the cutting attach-
ment is properly installed and fi rmly tight-
ened before operation.
NEVER use a cracked or warped cutting
attachment: If a properly installed attach-
ment vibrates, replace the attachment with
new one and re-check.
ALWAYS stop the engine immediately and
check for damage if you strike a foreign
object or if the unit becomes tangled.
Do not operate with broken or damaged
equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could dam-
age the engine.
T230X
This label indicates the minimum
distance between front handle
and rear grip per ANSI B175.3.
C230
IMPORTANT!
Safety and Operation Information Labels:
Make sure all information labels are
undamaged and readable. Immediately
replace damaged or missing information
labels. New labels are available from
your local authorized Shindaiwa dealer.
NEVER operate a unit with worn or dam-
aged fasteners or attachment holders.
NEVER cut with a dull blade. Doing so will
increase the risk of blade thrust and may
also cause equipment damage.
5