Advertisement
Available languages
Available languages
Always follow all safety precautions
when
cleaning
and servicing the POWER-MATE
TM,
WARNING
Electrical
Shock Or Personal injury
Hazard
Disconnect
electrical supply before
servicing
or cleaning the unit.
Failure
to do so could
result
in elec-
trical
shock
or personal
injury
from
cleaner suddenly
starting_
1. Remove light
cover by pressing
in and lifting both
sides as shown.
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise to remove,
3. Replace the bulb
Bulb must not be
higher than I5 Watts°
Close light cover until
it snaps in place°
NOTE: See PARTS AND FEATURES for
Bulb #.
Disconnect
cleaner from electrical
outlet.
Check and remove hair, string and lint build-
up frequently
in the POWER-MATE
TM
brush
and brush support areas. If build-up
becomes
excessive, disconnect
POWER-
MATE
TM
from wand and follow the steps
below_ Instructions
can atso be found under
the light cover.
TO REMOVE BELT:
._
1. Remove light
cover and light
bulb as shown
under LIGHT
'_
BULB
CHANGING.
_._
2. Unscrew the
POWER-
MATE
TM
cover
screws.
3. Turn
POWER-
MATE
TM
over.
To remove
cover, insert
screwdriver
at
cover tabs on
both sides and
twist to
release tabs
Quick
Release
4. Turn POWER-
MATE
TM
right
side up. Press
handle release
pedal and lower
the swivel° Tilt
cover forward
from back until
front snaps free.
14
Advertisement
