Kenmore 385. 1254180 Owner's Manual page 50

= Clean the Shuttle Race
This area must be kept free of dust, lint and occasional tangied thread, Ctean the shuttle race area
about every three months,
Center pm of
the shuttle
v r
case
J
To Ctean the Shuttle Area:
1. Raise the needle bar to its h_ghest
point and remove the bobbin case.
2. Push shuttle race levers aside. Lift
shuttle race cover and take shuttle out.
3. Clean the shuttle race with a lint
brush,
4. Put a drop of sewing machine oii on
the center pin of the shuttle. Do not
over-oil.
Shut[la dr_ver
Lever_
Shuttle Race
(Oil ._re)
Lever
Shu[tie
Shuttle Race
Cover
To Replace Shuttle Assembly:
1, Position shuttle race as illustrated so that shuttle
driver is forming half moon on the left side of the
machme,
2. Hold shuttle by center pin and position shuttle so as
to form a half moon on the right s_de. Pointed hook
will be on the bottom.
3, Place shuttle race cover into place over shuttle
assembly.
4. Snap the tevers back rote the original position.
48