Learn The Stitches; Straight Stitches; Use The Seam Guides; O Turn A Square Corner - Kenmore 385. 11607 Owner's Manual

SECTION 3. LEARN THE STITCHES
Straight Stitches
Straight Stitch
Set the Machine
Stitch
|
t
I
Top thread tension
control 2 to 6
Straight foot
Stitch selector
(Model 12714)
(Model 116071
Stitch length
controf red
zone
Zigzag foot
18
,, ,J
t. Raise the presser foot.
2. Raise the needle to its highest
position.
3. Place the edge of the fabric next
to a stitching guide line on the
needle plate (5/8" is most
common).
4. Draw the threads towards the
back and lower the presser foot.
5, Press the foot control,
6, Hold the fabric loosely and gently
guide it along the guide line, so
that it feeds naturally,
Do not force the fabric or try to
pull it tight.
7. At the end of the seam, you may
want to reverse to lock the stitch.
8. Raise the presser foot and remove
the fabric,
9. Cut the threads.
= Use the Seam Guides
Cornering Guide
7"he seam guides on the needle plate
are there to he]p you measure seam
width. The lines are t/8" apart, with
the 5/8" and 7/8" lines marked.
= Turn a Square Corner
........ ,,, J
To turn a square corner 5/8" from the
fabric edge:
1. Stop stitching and lower the
needle by turning hand wheel
toward you when the fabric edge
facing you lines up with the
cornering guide, as shown,
2. Raise the presser foot and turn
the fabric to line the edge with
the 5/8" seam guide.
3, Lower the presser foot and begin
stitching m the new direction.