Ibm Ibm San50C-R Front Panel Leds - IBM SAN50C-R Installation, Service And User Manual

Table 2. IBM IBM SAN50C-R front panel LEDs
LED Status
Status Green
Orange
Red blinking
Red
P/S Green
Red
Off
FAN Green
Red
Off
LINK Red
Off
ACT Orange
blinking
Off
1-48 Green
Green
blinking
Off
Description
All diagnostics pass. The module is operational
(normal initialization sequence).
The module is booting or running diagnostics
(normal initialization sequence)
An over-temperature condition has occurred. (A
minor temperature threshold has been exceeded
during environmental monitoring.)
One of the following occurred:
v The diagnostic test failed.
v An over-temperature condition has occurred.
(A major temperature threshold has been
exceeded during environmental monitoring.)
v The module is not operational because a fault
occurred during the initialization sequence.
The power is on, but it did not boot up the Diag
or iSAN image.
Power supply is OK.
Power supply failed.
The module is not receiving power.
Power supply is OK.
Power supply failed.
TheFAN is not receiving power.
The Ethernet port is connected to a device.
The Ethernet port is not connected to a device.
Data is being transmitted through this interface.
No data is being transmitted.
The link is up.
The link is up and traffic is passing through the
port.
The port is shut down
Chapter 1. Introducing the SAN50C-R
5