DSC TL2803GR Installation Manual page 21

OFF: A cellular trouble event is not generated when the radio signal level falls below
threshold level (average CSQ level is 4 or less).
[006] System Toggle Options 2
[1] Ethernet 1 receiver enabled. Default (ON) (OFF for 3G2080(R)).
ON: Ethernet receiver 1 is enabled.
OFF: Ethernet receiver 1 is disabled.
[2] Ethernet receiver 2 is enabled. Default (ON) (OFF for 3G2080(R)).
ON: Ethernet receiver 2 is enabled.
OFF: Ethernet receiver 2 is disabled.
[3] Reserved
[4] Cellular receiver 1 is enabled. Default
ON: Cellular receiver 1 is enabled.
OFF: Cellular receiver 1 is disabled.
[5] Cellular receiver 2 is enabled. Default
ON: Cellular receiver 2 is enabled.
OFF: Cellular receiver 2 is disabled.
[6] Reserved
[7] DLS Over Cellular. Default (ON).
NOTE: Program this toggle as OFF to prevent DLS from using the cellular path.
ON: DLS is enabled on the cellular path.
OFF: DLS is disabled on the cellular path.
NOTE: If this toggle is OFF, DLS sessions will occur on the Ethernet path only, regardless of the
primary path set in section [005] toggle option [4]. If it is ON, the communicator will con-
nect to the primary path first for DLS and if the session fails, the secondary path will be
used.
[8] Reserved
[007] DNS Server IP 1
Default (000.000.000.000)
Enter the IP address for DNS server 1. Format is 4 fields, each field is a 3 digit decimal. Valid
range: 000-255.
NOTE: If no value is programmed and DHCP is used, the DHCP server will configure the
address. If an address is programmed and DHCP is used, the address that you program
will be used instead of the DHCP address.
[008] DNS Server IP 2
Default (000.000.000.000)
Enter the IP address for DNS server 2. Format is 4 fields, each field is a 3 digit decimal. Valid
range: 000-255.
NOTE: If no value is programmed and DHCP is used, the DHCP server will assign this value. If
an address is programmed and DHCP is used, the address that you program will be used
instead of the DHCP address.
HSPA(3G) Alarm Communicator Installation Manual
(OFF for TL2803G(R)).
(ON).
(OFF for TL2803G(R))
(ON).
21