TF OUBLESHOOT NG
POHNTS
PROBLEM
Engine
continues to run
when operator leaves seat
with attachment
clutch
engaged
Poor cut - uneven
Mower blades will not
rotate
Poor grass discharge
Headlight(s)
not working
(if so equipped)
Battery will not charge
Engine "'backfires"
when turning
engine
"OFF"
CAUSE
I.. Faulty operator-safety
presence control system
1
Worn, bent or loose blade.
2.
Mower deck not level
3
Buildup of grass, leaves, and trash under mower..
4
Bent blade mandrel
5
Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels
I
Obstruction
in clutch mechanism..
2.
Worn/damaged
mower drive bell
3
Frozen idler pulley..
4
Frozen blade mandrel
1
Engine speed too slow,
2
Travel speed too fasL
3.
Wet grass.
4.
Mower deck not level.
5
Low/uneven
tire air pressure
6
Worn, bent or loose blade..
7.
Buildup of grass, leaves and trash under mower
8.
Mower drive belt worn
9
Blades improperly installed..
10..
Improper blades used
t I
Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels.
1.. Switch is "OFF".
2
Bulb(s) burned out
3
Faulty light switch..
4.
Loose or damaged wiring
5.
Blown fuse
t
Bad battery cell(s).
2
Poor cable connections
3.
Faulty regulator (if so equipped)
4.
Faulty alternator
1.
Engine throttle control not set at "SLOW"
position for 30 seconds before stopping engine.
CORRECTION
1
Check wiring, switches
and connections
If not
corrected, contact an authorized service center/
department.
1
Replace blade
Tighten blade bolt
2.
Level mower deck
3
Clean undersideol
mower housing
4
Replace blade mandrel.
5.
Clean around mandrels to open vent holes
1
Remove obstruction
2
Replace mower drive belt
3
Replace idler pulley
4
Replace blade mandrel.
1
Place throttle control in "FAST" position
2.
Shift to slower speed.
3
Allow grass to dry before mowing..
4
Level mower deck
5
Check tires for properair
pressure
6.
Replace/sharpen
blade. Tighten blade bolt
7.
Clean underside of mower housing
8
Replace mower drive belt
9
Reinstall blades sharp edge down.
10
Replace with blades listed in this manual
11_ Clean around mandrels to open vent holes.
1.
Turn switch "ON"
2
Replace bulb(s)
3.
Check/replace
light switch
4
Check wiring and connections
5
Replace fuse
1
Replace battery.
2
Check/clean
all connections.
3.
Replace regulator..
4
Replace alternator
1
Move throttle control to "SLOW" position and allow
to idle for 30 seconds before stopping
engine..
29