Table of Contents
Advertisement
Use the volume control wheel on the
right side of the headphones to adjust
the volume.
For best audio performance, wear the
headphones as indicated with L (Left)
and R (Right) on the ear pads. Do not
let anything cover the ear pads.
Caution
Do not store the headphones in
heat or direct sunlight. This could
damage the headphones and repairs
would not be covered by the vehicle
warranty. Storage in extreme cold
can weaken the batteries. Keep the
headphones stored in a cool, dry
place.
If the foam ear pads become worn or
damaged, the pads can be replaced
separately. To purchase replacement
ear pads, call 1-888-293-3332 or
contact your dealer.
Battery Replacement
To change the batteries:
1. Loosen the screw to the battery
door on the left side of the
headphones using a coin or
flat-head screwdriver.
2. Slide the battery door open.
3. Replace the two AAA batteries.
4. Replace the battery door and
tighten the screw.
Remove the batteries if the
headphones will not be used for a
long time.
Rear Seat Infotainment (RSI)
Wi-Fi (If Equipped)
The RSI Wi-Fi supports Miracast to
display smart devices directly on the
rear seat infotainment screens.
Miracast will only support one device
at a time. The smart device must
support Miracast, Screen Mirroring,
or Android Wireless Display.
The RSI Wi-Fi allows the user to
access music, videos and pictures that
are saved or taken with a smart device
to the RSI system through Digital
REAR SEAT INFOTAINMENT
Living Network Alliance (DLNA)
applications. Up to two devices can be
connected to the RSI at one time.
Miracast will only support one device
at a time.
Placement for Optimal Performance
The RSI Wi-Fi antenna is near the
back of the center console. The smart
device connection is stronger when it
is near the Wi-Fi antenna.
If the network is not operating at its
maximum effectiveness, try the
following:
Disconnect the smart device from
any other connected network to
improve the audio/video
performance.
Switch the band. While in any
Wi-Fi screen, select Menu, then
select Switch Band to access a
band that is available. Some
marketing regions will only
support 2.4 GHz.
Operation
From the Home Menu, select Wireless
Display to connect to an Android
device through Miracast, as a DLNA
31
Advertisement
Table of Contents
