Table of Contents
Advertisement
operating instructions
Stand mounting
1. Mount and fasten the Cine Reflector on the stand, using the locking knob on the Stand
Adapter [9].
2. The reflector can be directed upwards/downwards when the Tilt Locking Handle [3] is
loosened. Fasten the Tilt Locking Handle [3] when the reflector is correctly directed.
NotiCE!
The Stand Adapter [9] can easily be exchanged with other standard adapters for alternative ways of mounting to a
stand or overhead mounting.
SafEty PRECaUtioN!
When mounting overhead, secure all equipment from falling down by passing a steel safety cable through the handle
of the reflector and the lamp/flash head, as well as through the Accessory Loop [5] of all accessories.
NotiCE!
Both the Locking Bracket [6] and Accessory Brackets [7] are easily replaced by just loosening one screw for each
bracket. Complete sets with replacement brackets of 2 or 6 positions are available as Profoto accessories for the
Cine Reflector.
The accessories shall be placed in the positions of the Accessory Brackets as follows:
• The PAR reflector attachment shall be placed in the innermost position.
• If lenses are used they shall preferably be placed next to the PAR Reflector attachment.
• BarnDoors can only be placed in one of the two outer positions.
The accessories occupy the following number of positions in the Accessory Brackets:
• 1 position: PAR reflector, Scrims, Dichroic filters, Diffusion sheets, BarnDoors
• 2 positions: Fresnel lens
• 3 positions: PAR lenses
accessory combinations
With the standard Accessory Brackets (4 positions), the following recommended
accessory combinations are possible with the PAR reflector attachment mounted:
• PAR reflector attachment + Fresnel lens + BarnDoor
• PAR reflector attachment + Fresnel lens + Scrims or Dichroic filters
• PAR reflector attachment + PAR lens + BarnDoor
• PAR reflector attachment + scrim/filter/diffusion sheet + scrim/filter/diffusion sheet
+ BarnDoor
www.profoto.com
9
Advertisement
Table of Contents
