Sears 113.21308 Owner's Manual page 4

b. Drum sanders must NEVER be operated on
this driU press at a speed greater than 1800
RPM
c. Do not install or use any drill that exceeds 7" in
length or extends 6" below the chuck jaws, They
can suddenly bend outward or break.
d. Do not use wire wheels, router bits. shaper cut-
ters, circle (fly) cutters or rotary planers on this
drill press.
11. Note and Follow the Safety Warnings and In-
structions that Appear on the Panel on the
Right Side of the Head:
f
o FOR YOUR OWN SAFETY:
O
!
O m
KnowThis Tool! Read and Understand Owner'sManual beforeUsing this
Machine.Use Recommended Drill Speed- SeeChart Inside Pulley Cover.
m Always wear safety goggles that comply with ANSI Z87.1
m Donotwear gloves,necktie or looseclothing.Tie back _E
long hair. '-_N
= Securelyclamp work to table if itis too shorttocontact
the column when in operating position.
Securely lock head and support to column, and table
to support, before operating drillpress.
Use only recommended accessories. F_82443 O
12. This Drill Press has 3 speeds as listed below:
620 RPM
1300 RPM
3100 RPM
See inside of guard for specific placement of belt
on pulleys.
13. Think Safety. Safety is a combination of operator
common sense and alertness at all times when the
drill press is being used,
WARNING: DO NOT ALLOW FAMILIARITY (GAINED
FROM FREQUENT USE OF YOUR DRILL PRESS)
TO BECOME COMMONPLACE. ALWAYS RE-
MEMBER THAT A CARELESS FRACTION OF A
SECOND IS SUFFICIENT TO INFLICT SEVERE
INJURY.
The operation of any power tool can resutt in foreign
objects being thrown into the eyes. which can result _n
severe eye damage. Always wear safety goggles com-
ply with ANSI Z87.1 (shown on Package) before corn-
mencing power tool operation. Safety Goggles are
available at Sears retail or catalog stores.