Installing Belt Guard Knob; Tensioning Belt - Sears 113.21308 Owner's Manual

BELT GUARD KNOB
5ram DIA. x 12ram LONG
SCREW
iNSTALLING BELT GUARD KNOB
BELT GUARD KNOB
1, To attach belt guard knob, locate knob and 5mm
Dia x 12ram _ong pan hd screw in toose parts bag.
Insta!! screw in hote iocated in guard and attach
knob turning until tight.
WARNING: TO AVOID POSSIBLE iNJURY KEEP
GUARD IN PLACE AND iN PROPER WORKING
ORDER WHILE OPERATING.
TENSIONING BELT
NOTE: The Drill Press is shipped with the bett instaited,
but it should be properiy tensioned before use
1, Lift guard from right side and leave opened on
hinge,
2. Release Belt Tension Lock Handle _ocated on right
side of Drill Press head. Puil right side of motor
toward front of driit press to refieve spring tension
on belt. Tighten the belt tension lock handIe,
PAN HD. SCREW
3. Choose speed for drilling operation, and move belt
to correct position for desired speed.
NOTE: Refer to chart inside be}t guard for Recom-
mended Drilling Speeds.
t--
e8
I BELT
'TENSION
LOCK
HANDLE
(:::
._o
f.,,#)
1:::
4. Loosen belt tension lock handle and move right
side of motor rearward to apply tension to the belt,
5. Tighten Belt Tension Lock Handles.
NOTE: Belt SHOULD deflect approximately t/2" by
thumb pressure at mid-point of belt between pulleys.
6. Close belt guard,
7, If belt slips while drilling, readjust belt tension.
I
13