Sears 315.10186 Operator's Manual page 13

_1= WARNING: Always wear safety gogglesor safety
glasses with side shields when operatingtool,
Failure to do so could result in objectsbeing thrown
into your eyes, resultingin possibleserious injury,
DRILLING
See Figure 11.
When drillinghard, smooth surfaces, usa a canter punch
to mark the desired hole Iocallon.This wff!prevent the ddl[
bit from slippingoff canter as the hole is started. How-
ever, the lower speed feature allowsstarting holes without
canter punchingif desired. To accomplishthis, simply
operate your drillat lower speed untilthe hole Is started.
The matedsi to be ddlied shouldbe secured in a vise or
with clamp_ to keep It from turning as the drill bIt rotates.
Hold tool firmly and place the bit at the point to be drilled.
Depress the switch triggerto start tool.
Move the drillbit into the workpieca,applyingonly enough
pressureto keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
_= WARNING: Be prapaTedfor bindingor bit
breakthrough,When these situationsoccur, the drill
has a tendency to grab and kick oppositeto the
direction of rotationand couldcause toss of control
when breaking throughmaterial, if you are not
prepared, this loss of controlcan result in possible
sedous injury.
When drillingmetals, use a light oil on the drillbit to keep
it from overheating.The oil will prolongthe life of the bit
and increasethe ddltingaction.
it the bit jams in workplace or if the drillstalls, release
switch triggerimmediately,Remove the bit from the
workplace and determine the reasonfor jamming.
Fig. 11
13