Stoelting F431 Service Manual page 14

IntelliTec Control Setting Specifi cations
Basic Menu
Advanced Menu
Storage Menu
* The CutOut value needs to be adjusted to product requirements. Refer to the 2183408 - Specifi cation Sheet for F431
Control located in the plastic pouch behind the header panel.
DISPLAY Value
CutOut *
Cut In T 19°F
Cycles 20
Stir On 15 sec
Stir Off 300 sec
DISPLAY Value
On Time 28 sec
Off Time 450 sec
Stb Time 120 sec
Sl1DrvOn 120 sec
Sl1DrOff 180 sec
Sl2CutIn 32°F
Sl2CtOut 28°F
DftOffTm 600 sec
DISPLAY Value
Refriger Cabinet
CabCutIn 38°F
CabCtOut 34°F
Cab Off 13 min
Cab On 130 sec
Table 1-1 IntelliTec Control Setting Specifi cations
MODE DEFINITION
Serve Amp draw setting for cut out
Serve Temperature setting for cut in
Serve Freezing cycles before going into Standby Mode
Serve Stir-only on time
Serve Stir-only off time
MODE DEFINITION
Standby Freezing cycle "on" time (runs on timers only)
Standby Freezing cycle "off" time
Standby Total time in mode
Sleep 1 Drive motor "on" timer
Sleep 1 Drive motor "off" timer
Sleep 2 Cut in temperature
Sleep 2 Cut out temperature
No Sensor Default "off" time. Used in case of sensor failure
MODE DEFINITION
All Set to None, 1 Hopper, 2 Hopper, or Cabinet
All Refrigerated cab cut in temperature
All Refrigerated cab cut out temperature
No Sensor Default "off" time. Used in case of sensor failure
No Sensor Default "on" time. Used in case of sensor failure
6