Kenwood TS-990S Setting Manual page 13

6) In the third list, in the "PC" section of the window, set the "Microphone". This is where
the computer microphone used for audio input to be transmitted is set. In the above
example, "Microphone (High Definition Audio)" is selected.
7) In the forth list, in the "PC" section of the window, set the "Speakers" device. This is
where the computer speakers used for playing incoming audio are specified.
Clicking the "RX AF Test" button plays a test signal from the selected speaker.
Next, continue to follow the steps below to confirm that the intended audio transmission
route is configured.
8) Connect a dummy load to the TS-990S.
9) If the TS-990S is in Split mode, switch to Simplex mode, with the mode set to SSB
(USB or LSB).
10) Enable the transmission monitor function.
11) Press the PF key set as DATA SEND to transmit.
12) From the ARUA-10 window shown above, click the "TX AF Test" button. If test
signals are played from the internal TS-990S speakers, the system is set up correctly.
Press the PF key set as DATA SEND to return to audio reception mode.
If the test signal does not play, check the settings and try the test again.
13) From the ARUA-10 window, click the "Save" button to complete the setup.
14) From the ARUA-10 window, click the "Close" button to close the window.
15) Right-click on the
select "Start". The icon in the task tray changes to
icon in the task tray to display the menu. From the menu,
12
and the ARUA-10 starts.