BKI BLF-FC Installation & Operation Manual page 16

Electric Autolift Fryer
Item # Description
1 Computer
2 Capacitive Touch
Switch Basket Up/
Basket Down
3 Capacitive Touch
Switch Filter/Off/Fry
4 Digital Timer /
Thermostat
LED indicators
P, C, H
1, 2, 3, 4, 5 & 6
preset buttons
Beeper
Display
5 High Limit Reset
Switch
6 Drain Lever
7 Fill Lever
8 Rinse Hose
Connector
Function
Used to program the cooking computer and activate the programs.
BASKET UP – Momentarily touching the button causes the lift
mechanism to rise. This is enabled only when the FILTER/OFF/FRY
switch is in the FRY position.
BASKET DOWN – Momentarily touching the button causes the lift
mechanism to lower. This is enabled only when the FILTER/OFF/FRY
switch is in the FRY position.
FILTER – When touched, the LED light next to it will light up and
power is applied to the motor and shorting is pumped into the pot
directly or thru the fill hose.
OFF – When touched, the LED light next to it will light up and power is
removed from the pump motor, heating elements and lift mechanism.
FRY – When touched, the LED light next to it will light up and power is
supplied to the thermostat, heating elements and lift mechanism.
The digital timer / thermostat consists of 3 LEDs, display, beeper and
6 buttons described below:
During the MLt & HEAt cycle the P LED will flash. When running a
timing cycle the C LED will flash. When idle and
H is not used
These buttons are used to save and recall preset cycle times, saving
operator time and minimizing error when changing interval cycle time.
To recall any preset time, press and quickly release the appropriate
button and the time starts to count down.
A beeper sounds when the timer counts down to 0. Pressing any of
the number button stops the beeper and resets the timer to the
state.
Used to display the time & temperature. It also displays the words
"MLt" then "HEAt" until the frying temperature is reached and
when the fryer is ready to cook.
Located under the control panel. If the heating elements inside the pot
reach an unsafe temperature, power is automatically removed from
the control panel, lift mechanism and elements. Pressing this switch
returns power to the control panel, lift mechanism and elements.
DRAIN OPEN – When placed in this position, the drain valve opens
and shortening in the pot drains into the vat. Also, power is removed
from the control panel, lift mechanism and elements.
DRAIN CLOSED – When placed in this position, the drain valve is
closed to prevent shortening from draining into the pot.
FILL THRU POT – When placed in this position, shortening can be
pumped automatically from the vat to the pot if the rocker switch is in
the FILTER position.
FILL THRU HOSE – When placed in this position, shortening can be
pumped from the vat to the pot via a connected hose if the rocker
switch is in the FILTER position.
Used to connect the Rinse hose for cleaning and refilling the pot.
13
Operation
rdY the C LED is on.
rdY
rdY