User Interface Operation - Wolf CW24 Service Manual

Electronics

User Interface Operation

Program the unit without DELAY START
1 Press ON/MENU. TEMP and 85° F flashes on the
display (See Figure 2-2).
2 Press the MORE button to increase the tempera-
ture.
NOTE: The display flashes three times then shuts off if
no other button is pressed.
3 Press ON/MENU when desired temperature is set.
4 TIMER and 0h00 flashes on the display (See Figure
2-3).
5 Press LESS/OFF or MORE button to set the amount
of time the unit is to run between one minute and
four hours.
6 Press ON/MENU when desired time is set.
7 DELAY START and 0h00 flashes on the display.
8 Press ON/MENU, the temperature flashes for three
seconds, then the fan comes on.
9 The display alternates between the setpoint temper-
ature and the remaining time on the timer.
Program the unit with DELAY START
1 Press ON/MENU. TEMP and 85° F flashes on the
display (See Figure 2-2).
2 Press the MORE button to increase the tempera-
ture.
NOTE: The display flashes three times, then shut off if
no other button is pressed.
3 Press ON/MENU when desired temperature is set.
4 TIMER and 0h00 flashes on the display (See Figure
2-3).
5 Press LESS/OFF or MORE button to set the amount
of time the unit is to run between one minute and
four hours.
6 Press ON/MENU when desired time is set.
7 DELAY START and 0h00 flashes on the display.
8 Press LESS/OFF or MORE button to set the amount
of time before the unit starts, between one minute
and nine hours, 50 minutes (See Figure 2-4).
9 Press ON/MENU when the desired time is set.
10 Temperature flashes for three seconds, then the dis-
play shows the time remaining until the unit starts.
11 When the DELAY START time expires, the unit
starts and the display alternates between the set-
point temperature and the remaining time on the
timer.
#9001337 - Revision A - September, 2015
Cup Warming Drawer (CW24)
Cup Warming Drawer (CW24)
2-4
Figure 2-2. Setting Temperature
Figure 2-3. Setting Timer
Figure 2-4. Delay Start Display