Component Removal - Wolf CW24 Service Manual

Cup Warming Drawer (CW24)
Cup Warming Drawer (CW24)
Anti-sliding Liner
To remove the anti-sliding liner, first open the cup warm-
ing drawer, then lift the anti-sliding liner by the tappered
corner located in the right rear or left front of the drawer.
Tray and Front Cover Assembly
To remove the tray and front cover assembly, first open
the cup warming drawer, then (See Figure 3-1):
1. Use a T-20 to extract two screws entering the left
and right slide horizontally.
2. Use a T-10 to extract the two screws entering the
left and right slide vertically.
3. Pull the tray and cover assembly forward and lift
from the slides.
Right and Left Slides
The right slide includes the Push To Open (PTO)
assembly. To remove either slide, first remove the tray
and cover assembly, then (See Figure 3-2):
1. Remove the unit from the installation.
2. Use a T-20 to extract the four screws on the lower
side of the cup warming drawer, on the side of the
slide to be removed.
3. Remove the slide.
Exhaust Fan, User Interface, and Exhaust
Fan Cover
To remove the exhaust fan assembly, first remove the
tray and cover assembly, then (See Figure 3-3):
1. Remove the unit from the installation.
2. Remove the power cord from the back of the unit.
3. Use a T-20 to extract the four screws on the left side
of the unit holding the exhaust fan assembly.
Figure 3-1. Screws Tray and Front Cover
Figure 3-2. Screws for Slides
Figure 3-3. Screws for Exhaust Fan Housing
3-3
#9001337 - Revision A - September, 2015

Component Removal