Installation: Product Specifications - Scotsman Self Contained Cuber CU1526 User Manual

CU1526, CU2026, CU3030
User Manual

Installation: Product Specifications

Location Limitations:
The product is designed to be installed indoors, in
a controlled environment. Air cooled models
discharge very warm air into the room. Water
cooled models discharge warm water into the
building's drain. Space needs to be provided for
service access.
Space Limitations
Do not block air flow at the front.
Room Temp Air In
Air Flow - Do Not Restrict
Airflow for air cooled models is in the front left and
out the front right; CU3030 air cooled models also
take air in from the bottom of the cabinet
Built In Situations:
•
If built in under the counter with no space
above, the bin cannot be removed without
moving the unit.
•
If built in with 1" or more clearance above the
unit, the bin can be removed without moving
the unit.
•
If built in with between 1/2 and 1 inch of
clearance, releasing the top panel's back flap
prior to placement will allow removal of the
bin without moving the unit.
In most cases, CU3030 air cooled models installed
without legs or casters will experience reduced ice
making capacity.
Environmental Limitations
Air temperature
Water temperature
Water pressure
Note: Ice making capacity will be severely reduced
for air cooled machines in hot environments, such
as those over 95 degrees.
Power supply – acceptable voltage ranges
115 volt model
230 volt model
Warranty Information
The warranty statement for this product is provided
separately from this manual. Refer to it for
Warm Air Out
applicable coverage. In general warranty covers
defects in material or workmanship. It does not
cover maintenance, corrections to installations, or
situations when the machine is operated in
circumstances that exceed the limitations printed
above.
Product Information
The product is a self contained cuber with bin. That
type of machine is designed to be free standing or
it can be built in under the counter.
Options
Casters may be used in place of the supplied legs,
the kit number is KBC1.
When not using legs or casters, most codes
require sealing to the floor. Kit numbers to allow
sealing are KPUFM26 and KPUFM30.
May 2008
Page 2
Minimum Maximum
o o
50 F. 100 F.
o o
40 F. 100 F.
20 psi 80 psi
Minimum Maximum
104 126
198 253