Maintenance And Troubleshooting - NordicTrack FREESTRIDE User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
The console requires activation. If you have not
activated the console, see assembly step 11 on
page 11.
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 20 and
adjust the contrast level of the display.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
TABLET HOLDER TROUBLESHOOTING
If the tablet holder does
not stay in place, rotate
the tablet holder backward
and tighten the screw (A)
until the tablet holder stays
in place when it is rotated
to the desired position.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted. To adjust the drive belt,
first unplug the power adapter.
Next, remove the M4 x 16mm Screw (98) and the
Access Cover (24) from the Right Inner Shield (21).
Then, tighten the M10 x 80mm Screw (95) until the
Drive Belt (72) is tight.
When you have properly adjusted the Drive belt (72),
reattach the Access Cover (24) and plug in the power
adapter.
A
21
21
24
98
95
72