Polar Electro RCX3 Getting Started Manual page 9

Take a New Sensor Into Use
Before you can start training you have to
activate and introduce all the sensors to
your training computer. This is called
pairing. It has to be done only once to
each sensor and it only takes a few
seconds.
Pairing ensures that your training
computer receives signals from your
sensors only, and enables
interference-free training in a group.
Pairing the heart rate sensor with the
training computer
Paring the heart rate sensor included in
the product package is done
automatically and it does not require any
special actions from you.
Before entering an event, make sure to
perform the pairing process at home. This
is to prevent interference due to the
long-range data transmission.
1. Wear the training computer and the
heart rate sensor. See instructions on
chapter Training (page 11).
Press OK. Searching for new
2.
heart rate sensor is displayed.
When Heart rate sensor found is
3.
displayed, you are ready to start your
first training session.
ENGLISH 9