Storage Instructions; Troubleshooting - Napa 00-99-000942 Owner's Manual

12.3 Servicing does not require opening unit, as there are no user-serviceable
parts.
13.

STORAGE INSTRUCTIONS

13.1 Store charger unplugged, in an upright position. Cord will still conduct
electricity until it is unplugged from outlet.
13.2 Store inside in a dry, cool place (unless you're using an on-board Marine
Charger ).
13.3 Do not store clips on handle, clipped together, on or around metal, or
clipped to cables.
14.

TROUBLESHOOTING

PROBLEM
A battery is connected but
the LCD display still shows
CONNECT BATTERY
The LCD display shows:
CHARGE ABORTED, BAD
BATTERY and beeps four
times
The LCD display shows:
BAD BATTERY and beeps
four times then switches to
CONNECT BATTERY
POSSIBLE CAUSE
The battery clips are not
making a good connection.
The battery connections are
reversed.
The battery is severely
discharged.
The battery is defective (will
not accept a charge).
Weak or sulfated plate in the
battery.
Wrong battery voltage.
The battery is bad or
sulfated.
8
• •
REASON/SOLUTION
Check for a poor connection
to the battery and/or frame.
Make sure connection points
are clean. Rock the clips
back and forth for a better
connection.
Unplug the charger and
reverse the clips.
If your battery does not have
.2V, you must press and
hold the CHARGE ON/OFF
button for five seconds to get
the charge cycle started.
Have the battery checked.
Have the battery checked.
Verify the CHARGE VOLT-
AGE setting on the charger.
Make sure it matches the
battery being charged.
In the case of a severely dis-
charged battery, the charger
will go into abort mode. If,
after the output turns off, the
battery voltage drops to un-
der .2 volts, the charger will
reset to the default settings
and the display will show
12V FAST on the top line
and CONNECT BATTERY
on the bottom line.